A step-by-step guide to install or change a kitchen sink faucet
Thinking about upgrading your kitchen faucet but not sure where to start?
Whether you're renovating your space or simply replacing an old fixture, this kitchen faucet installation guide will walk you through every step. Learning how to change a kitchen sink faucet might seem daunting, but with the right tools and clear instructions, it’s a manageable DIY project. In this article, we’ll show you how to install a new kitchen sink faucet efficiently and safely—no need to call a plumber!
Tools and Materials You’ll Need
Before you begin, make sure you have:
- A new faucet (compatible with your sink)
- Adjustable wrench or basin wrench
- Screwdriver
- Plumber’s tape (Teflon tape)
- A bucket or towel
Step 1 : Shut off the water
Start by turning off the hot and cold water valves under the sink. Then, open the faucet to release any remaining water and relieve pressure.
Pro tip: If you can’t find the shutoff valves or they’re stuck, turn off your home’s main water supply.
Step 2 : Disconnect the supply lines
Place a bucket or towel under the sink to catch any residual water. Use a wrench to disconnect the water supply lines from the faucet. Keep the washers if they’re still in good condition—or replace them if needed.
Step 3 : Remove the Old Faucet
Locate the mounting nuts under the sink and unscrew them (they’re usually plastic or metal). Once loose, lift out the old faucet from above. Clean the sink surface with a damp cloth to remove grime or old putty.
Step 4 : Install the New Faucet
Insert the new faucet through the mounting holes in your sink. From underneath, secure it with the provided nuts. Hand-tighten first, then use a wrench to finish (be careful not to overtighten). Apply plumber’s putty if recommended by the manufacturer.
Step 5: Reconnect the water supply lines
Reconnect the hot and cold supply lines to the new faucet. Add a bit of plumber’s tape to the threads to ensure a tight, leak-free seal. Tighten with a wrench, but don’t overdo it.
Step 6 : Turn the water back on and test
Slowly reopen the shutoff valves under the sink. Turn on the faucet and check for leaks—both around the base and under the sink.
Pre-order yours now!
Pre-order now!
